INSTALLATION INSTRUCTIONS
11. Using an 18mm socket, remove the two tow hook bolts and remove the tow hook completely. Repeat for other side.
Figure 7
12. Dismount the temperature sensor bracket by pulling out at the bottom of the bracket and then down.
13. Separate the temperature sensor from the factory plastic bracket and discard bracket. NOTE: The sensor will be reinstalled with a new bracket.
Figure 8
14. Remove plastic air dam from factory bumper. a. Use a T-15 bit to remove the six screws securing the air dam reinforcement brackets. Note: You will be reinstalling brackets later. b. Remove the 13 remaining screws retaining the air dam using a T-15 bit.
Reinforcement bracket screws
Figure 9
15. Remove center plastic valance by releasing the 12 retaining clips.
16. Reinstall the reinforcement brackets.
Figure 10
105843A0
©2019 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
6
Powered by FlippingBook