INSTALLATION INSTRUCTIONS
6. Remove the two bolts from the front center vents with a 10mm socket. NOTE: They are only accessible with an extension. Repeat for other side. 7. From underneath the truck, looking towards the front, remove the four screws (two on each side) along the bottom edge, using a T-15 bit.
CAUTION Always use assistance when moving or lifting heavy parts.
8. The bumper and grille can now be removed as one piece. With assistance, start from the edges and carefully pull bumper and grill forward and off the vehicle. NOTE: On each side, above the fog light and near the frame rail, there is a clip that must be released while under tension. Squeeze the metal ears together while an assistant pulls on the bumper.
Figure 4
Three push clips
Once the bumper and grille are free from the vehicle, set bumper face down on a flat, clean and stable surface.
9. Remove the air duct by first removing the three push clips along the top edge, and then releasing the single clip on each side as shown in the detail views.
Single clips
Figure 5
10. Using a 15mm socket, remove the four crash bar bolts and remove bumper reinforcement bar from the frame of the truck. Save hardware for reuse.
Figure 6
105843A0
©2019 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
5
Powered by FlippingBook