HINT: If you are installing a WARN synthetic winch, be sure to install rope to winch BEFORE installing winch to mount.
15. Install fairlead, per instructions found in winch kit.
16. Install winch to mount per winch kit instructions.
17. Run rope through fairlead.
18. Make wire connections per winch kit install instructions.
Figure 12
19. Re-install plastic shrouds (each side) of radiator. HINT: You will need cut shrouds to fit around new mount.
Cut shroud to fit around mount
Figure 13
Modifying front plastic:
20. Remove center portion of plastic.
a. Use 1” wide tape mark off area to trim, as shown in the picture. NOTE: The tape will help protect the areas you don’t want your cutting tool to scratch.
Mark center plastic for cutting
Figure 14
21. Using a reciprocating fine tooth air saw or the like; cut to the inside edge of the tape. Try not to cut the tape.
Be sure to leave nice clean edges on all sides (use a small disk sander to clean any rough edges) .
22. Once center portion of plastic is removed. Cut off the two tabs in the center of plastic piece.
Cut front plastic and center tabs completely off
Figure 15
7
100028A0
©2016 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
Powered by FlippingBook