30. Re-install the push pull clips from the plastic cover over the radiator.
Figure 20
31. Use the straps (A5) and the 5/16 hardware (B11, B10, B9 and B10) to attach the lower plastic to the mount. NOTE: The fender washer (B10) is used on the side of the strap that attaches the plastic. The plastic has a large hole that needs a fender washer.
A5
32. Install the remote plug end (A4), in desired location, with the hardware supplied in the kit.
33. Your installation is now complete. Tighten all hardware at this time.
B11, B10, B9 AND B10
Figure 21
MAINTENANCE / CARE 1. Inspect all parts on the winch, winch mount, and related hardware prior to each use. Replace all hardware that appears rusted or deformed.
2. Inspect all nuts and bolts on the winch, winch mount and related hardware prior to each use. Tighten all nuts that appear to be loose. Stripped, fractured, or bent bolts or nuts need to be replaced.
3. Check all cables prior to use. Replace cables that look worn or frayed.
4. Check all moving or rotating parts. Remove debris that may inhibit the part from moving freely.
9
100028A0
©2016 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
Powered by FlippingBook