INSTALLATION INSTRUCTIONS
5. Remove the side airflow panels, by removing one push/pull clip and carefully pulling away from vehicle clip/tabs.
NOTE: You will be trimming these after the mount is installed and reinstalling them into original location.
Clip
Figure 4
6. Remove the three hood latch screws (at the top) and the one power steering cooler screw.
7. Remove the four push/pull plastic clips.
Latch/ Power steering Hardware
Clips
Figure 5
8. Remove the six nuts from the cross bar (two in each corner and two in center).
Crossbar Hardware
Figure 6
9. Unplug lower wire harness and then unclip one side from crossbar.
Unplug
Unclip
Figure 7
5
100125A1
©2018 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
Powered by FlippingBook