I N S T A L L A T I O N I N S T R U C T I O N S
10. Unclip all the plugs holding the sensor harness to the bumper using a body pry tool. Carefully remove the sensor from the housing by pushing the housing apart and removing the sensor by pushing up. (Figure 9)
Figure 9
11. Remove the sensor housings from the bumper by pressing the four (4) clips in and pushing it out of the bumper. Make sure to mark what side of the bumper the housing came out of to install into the Fab Fours bumper. (Figure 10)
Figure 10
12. Remove the engine heater plug from the bumper by pressing in on the spring and turning clockwise. (Figure 11)
Figure 11
7
Powered by FlippingBook