I N S T A L L A T I O N I N S T R U C T I O N S
21. Center the backer strip with grill and while using a 9/16” socket wrench, fully tighten the outer two bolts followed by the inner two bolts. (Figure 17) Note: A bow will form in backer strip when fully tightened down. This is intended to match the curvature of the grill.
Figure 17
22. Using the provided epoxy, secure all four (4) OEM sensor housings in their appropriate sensor cutout in the bumper (22335). (Figure 18)
Figure 18
23. Using a pair of wire snips, clip off all the push retainers from the factory wiring harness.
24. After the epoxy has cured, fully seat all four (4) sensors into the sensor housings being mindful not to distort the rubber sensor isolator that sits around the sensor tip. Be sure both sides of the sensor housing are fully clipped on the sensor.
25. Route and zip tie the factory wiring harness to the bumper (22335) with the main factory connector being on the passenger wing.
11
Powered by FlippingBook