I N S T A L L A T I O N I N S T R U C T I O N S
19. Route and reconnect the two (2) OEM wiring harness plugs from the factory louver system behind the frame rail end of the driver side fame rail end. If equipped, route the engine heater plug wiring behind the fame rail also. Zip tie and secure the wiring bundles as desired. (Figure 15)
Figure 15
20. Using the provided four (4) bolt stacks of 3/8”-16 yellow zinc hex bolt, flat washers, lock washer, and hex nut, loosely install the backer strip (22229) to both brackets (22226 & 22227). (50250-HW) (Figure 16) Note: Cracking the bracket bolts can alleviate any bolt misalignment issues with the backer strip to brackets. Be sure to retighten all bracket hardware if loosened.
Figure 16
10
Powered by FlippingBook