16. Using a deep 14mm socket, remove the 6 nuts holding the crash bar to the frame extensions. Save nuts to be reused later.
Figure 12
17. With the crash bar removed, use a 14mm deep socket to remove the six nuts securing the frame extensions. Save nuts to be reused later. These nuts will be reused in the mounting of the new kit.
Figure 13
18. Remove frame extension.
19. With the bumper cover on a stable surface, it can now be modified to fit the new kit.
Figure 14
20. Using a pneumatic reciprocating saw or other suitable tool, cut along the lines shown. Be sure to cut inside the body lines to leave as much of the original plastic intact as possible. Be careful to not damage the paint on other areas of the bumper cover. NOTE: It may be helpful to mask the areas near around the cuts to prevent damage during modification and installation.
Figure 15
7
102877A0
©2018 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
Powered by FlippingBook