INSTALLATION INSTRUCTIONS
13. Attach the Frame Brackets to the Bumper with 2 each 7/16 x 1-1/4” capscrews and flat washers, lock washers and hex nuts per side. Do not tighten yet. Figure 17.
14. Attach the vacuum canister to the Relocation Bracket with the (2) 6mm capscrews and flat washers provided. Use the 6mm flange bolts, lock nuts and washers to secure it. Make sure the canister, hoses, fittings and wires are not strained, kinked, pinched or rubbing against any moving parts. Use wire ties as needed. Figure 17. 15. Tighten the hardware to the correct specifications. Tighten the 8 Bumper mounting bolts, the 4 Frame Bracket to Bumper bolts then the 5/8” Frame Bracket to Frame bolts. Next, tighten the Canister Relocation Bracket then the canister (if equipped).
Figure 17
16. Install the fairlead plate with the cut out corners pointing down. Use the centered plate if the winch will be mounted using the centered hole patters. Use the offset plate if the winch will be mounted using the offset hole pattern. DO NOT MIX THE PLATES. Using the incorrect plate can damage the winch and/or winch rope. Figure 18.
a. Install the fairlead, use the 7/16 x 1-1/4 capscrews, flat washers, lock washers and nuts to secure the fairlead plate. Install the capscrews from the rear to avoid interference with the winch. Use the hardware that came with the fairlead to attach the fairlead.
Figure 18
17. Install the winch. Select the best mounting hole pattern. . NOTE: The motor ground cable may need to be rotated at the motor to avoid interfering with the frame bracket bolts. Figure 20. Use the hardware supplied with the winch. Tighten to the torque specification supplied with the winch.
Figure 19
Canister bracket installed
18. Two holes are provided in the Bumper face for license plate installation.
Rotate ground cable to this position
19. Remove the factory fog lamps from the factory bumper by removing the 4 Phillips screws around each lamp. Figure 20.
Figure 20
9
87926A7
Powered by FlippingBook