INSTALLATION INSTRUCTIONS
10. Bolt the Canister Relocation Bracket to the support bracket using 1/4-20-1” capscrews. Do not fully tighten yet. See Figure 13.
Canister bracket installed
Figure 13
11. Install the Support Brackets. The brackets are the same. Use 5/8 X 1-1/2” bolts and flat washers through the rear slot for driver’s side and front slot for passenger’s side. Use the 5/8” nut plates inside the frame. Figure 14. Position them as shown in Figures 15. Do not tighten yet.
Nut plate
Figure 14
Frame bracket installed
Figure 15
12. Install the bumper using 8 each (4 per side) 7/16 x 1-1/4” capscrews with flat washers and lock washers through the back of the frame pads into the bumper. Install 2 ( 1 per side) 7/16 nuts and washers on the top-outside bolts. Figure 16.
Figure 16
8
87926A7
Powered by FlippingBook