20. Enlarge each fog lamp mounting hole to 1/4”.
Remove screws and enlarge holes
21. Attach the fog lamps to the Fog Lamp Brackets using the 1/4-20 x 1” capscrews, flat washers and lock nuts. Make sure the fog lamp vents are on top. Figure 21.
22. Install the left and right Fog Lamp Bezels. Use 6 each 8-32 x .75 hex socket screws for each bezel. Install flat washers and lock nuts on the back of the bumper and tighten. These fasteners need only to be snug. Do not over tighten.
23. Install the fog lamps and Brackets. Use 7/16 x 1-1/2” capscrews, flat washers, lock washers and nuts. Adjust lamps and tighten. Figure 21.
Figure 21
24. Reconnect the fog lamp wires to the lamps. Secure the fog lamp wires with wire ties.
NOTE: Non-Factory Auxiliary Lights: Many 4” or smaller after- market fog and driving lamps can be used in the light ports if they can be mounted with the stem to the side. Check with the manufacture of the light to make sure they can be used in this way. Mount directly to the slots in the bumper gussets. If the light stems are too short use the supplied Light Mount Brackets. If you use the Light Mount Brackets use 7/16 x 1-1/4 cap- screws, nuts and flat and lock washers for the bracket. WARN has a number of auxiliary light options that work in this application. Call Warn Customer Service or check online for a list of current available models. NOTE: Four extra 7/16” washers are supplied with the hard- ware kit. These are intended to aid in centering non factory auxiliary lights including Warn W350F.
Figure 22
Figure 23
CARELESS INSTALLATION AND OPERATION CAN RESULT IN SERIOUS INJURY OR EQUIPMENT DAMAGE. READ AND UNDERSTAND ALL SAFETY PRECAUTIONS AND OPERATING INSTRUCTIONS BEFORE INSTALLING AND OPERATING THIS PRODUCT.
10
87926A7
Powered by FlippingBook