15. Unclip the remaining lower clips by squeezing the locking tangs through the slots in the bumper cover.
Remaining clips
16. The bumper cover can now be lifted away from the valence panel.
Figure 13
17. With the bumper cover on a stable surface, it can now be modified to fit the new kit.
18. Using a pneumatic reciprocating saw or other suitable tool, cut along the lines shown. Be sure to cut inside the body lines to leave as much of the original plastic intact as possible. Be careful to not damage the paint on other areas of the bumper cover. NOTE: It may be helpful to mask the areas near around the cuts to prevent damage during modification and installation.
Figure 14
19. Using a deep 14mm socket, remove the 6 nuts holding the crash bar to the frame extensions. Save nuts to be reused later.
Figure 15
20. With the crash bar removed, use a 14mm deep socket to remove the six nuts securing the frame extensions. Save nuts to be reused later. These nuts will be reused in the mounting of the new kit.
Figure 16
7
102875A0
©2018 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
Powered by FlippingBook