38. Install frame bracket strap (A2) and reinstall factory bolt in same position just removed.
A3 bolt and Factory nut
39. Install kit bolt (A3) in other hole and secure with one of the remaining factory nuts.
40. Repeat for other side.
Factory bolt
A2
Figure 31
41. Reinstall grille.
42. Push the grille back into the locking tabs and slots located at the bottom corners.
43. Reinstall the two outer push pins and two center screws.
Figure 32
License mounting location
44. Install license plate with hardware included (A4 & A5).
Figure 33
MAINTENANCE / CARE 1. Inspect all parts on the winch, winch mount, and related hardware prior to each use. Replace all hardware that appears rusted or deformed.
2. Inspect all nuts and bolts on the winch, winch mount and related hardware prior to each use. Tighten all nuts that appear to be loose. Stripped, fractured, or bent bolts or nuts need to be replaced.
3. Check all cables prior to use. Replace cables that look worn or frayed.
4. Check all moving or rotating parts. Remove debris that may inhibit the part from moving freely.
11
102875A0
©2018 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
Powered by FlippingBook