4. Terminate the ends of the two 5/16” dia x 1-3/8” wide U-bolts (C2) with 5/16” dia flat washers (C3) and 5/16” dia nylock nuts (C4) as shown in figure 4. 5. Tighten all the 5/16” dia nylock nuts (C4) on the plow mount (A1) to a recommended torque of 12 ft-lb (16 N-m). The completed plow mount should look like figure 5. WARNING Tighten all nuts and bolts securely. Failure to check all nuts and bolts prior to use can result in product failure which can lead to vehicle damage and operator injury or death. 6. If not already done so, assemble the plow per the instructions that came with the plow blade kit. Attach the plow to the plow mount (A1) using the clip pins that came with the plow blade. If using an electric actuator or manual lift to raise your plow, stop here and proceed to section IV, Maintenance/Care. Winch users continue with step 7. 7. Attach the J-bolt bracket (A2) to the center hole in the plow crossmember using a 3/8” dia x 1” long bolt (D1) as shown in figure 6. The bracket should be mounted on the blade side of the crossmember with the side flanges parallel to the ground. Terminate the bolt with a 3/8” dia flat washer (D2) and 3/8” dia nylock nut (D3). Tighten the bolt and nut to a recommended torque of 20 ft-lb (28 N-m).
Rear of Vehicle
C2, C3, & C4
Figure 4 Install Remaining Fasteners
Figure 5 Completed Plow Mount
D1, D2, & D3
A2
Figure 6 Installed J-bolt Bracket
WARN® INDUSTRIES
PAGE 4
65071 Rev A1
Powered by FlippingBook