III. Installation 1. Slide two 5/16” dia x 1-1/8” wide U-bolts (C1) over the rear frame cross tubes as shown in figure 1. 2. Place the plow mount (A1) under the vehicle, and slide the legs of the U-bolts through the four rear holes in the plow mount. Terminate the U-bolt legs with 5/16” dia flat washers (C3) and 5/16” dia nylock nuts (C4) as shown in figure 2. NOTE: Do not tighten the bolt and nut completely. You will do this later in the installation. 3. Slide two 5/16” dia x 1-3/8” wide U-bolts (C2) over the large side frame tubes under the vehicle and through the plow mount (A1) as shown in figure 3.
C1
C1
Front of Vehicle
Figure 1 Install Rear U-Bolts
C1, C3, & C4
A1
Front of Vehicle
Figure 2 Install Plow Mount
C2
C2
Rear of Vehicle
Figure 3 Install Front U-Bolts
WARN® INDUSTRIES
PAGE 3
65071 Rev A1
Powered by FlippingBook