INSTALLATION INSTRUCTIONS
5. Remove the three screws from the front wheel well (each side) separating the exterior plastic from the inner fender.
Screws
Figure 5
6. Carefully pull exterior plastic away from wheel well until plastic unsnaps from clip on vehicle.
Figure 6
7. Before removing the front clip reach in and unplug your fog lamps. With help gently start pulling the front clip from the vehicle making sure all connections release so not to damage plastic.
Figure 7
8. Remove the foam from the aluminum cross tube to access the six nuts.
9. Remove aluminum cross bar by removing the three nuts (each side) securing aluminum cross tube to frame extension brackets. NOTE: You will not be reusing cross bar. 10. Remove the eight bolts securing the extension brackets to frame. Completely remove brackets - you will not be reusing.
Remove (8) bolts securing frame extension brackets
Remove foam and (6) aluminum cross bar nuts
Figure 8
5
100028A0
©2016 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
Powered by FlippingBook