I N S T A L L A T I O N I N S T R U C T I O N S
19. Using the provided four (4) bolt stacks of 3/8”-16 yellow zinc hex bolt, flat washers, lock washer, and hex nut, loosely install the backer strip (22251) to both brackets (22226 & 22227). Center the backer strip with the grill and fully tighten with a 9/16” socket wrench. (50250-HW) Figure 21.
20 . Using the provided epoxy, secure all four (4) OEM sensor housings in their appropriate sensor cutout in the bumper (110912-4). Figure 22.
21 . After the epoxy has cured, fully seat all four (4) sensors into the sensor housings being mindful not to distort the rubber sensor isolator that sits around the sensor tip. Be sure both sides of the sensor housing are fully clipped on the sensor. 22. Route and zip tie the factory wiring harness to the bumper (110912-4) with the main factory connector being on the passenger wing.
23 . Install the light housings (94888-94889) into the bumper using the #10 stainless steel bolts, flat/lock washers and nuts (50250-HW). Figure 23.
110912-4
©2019 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
7
Powered by FlippingBook