110912-install-instr-warn-ascent-hd

I N S T A L L A T I O N I N S T R U C T I O N S

24. With assistance, lift the bumper up to the brackets (22226 & 22227) and secure it loosely using the provided four (4) bolt strips (20296) and eight (8) 1/2”-13, yellow zinc hex nut, flat washers, lock washer. Figure 24-25. (50250-HW)

2 5 . With assistance of two, lift and center the bumper to the vehicle and using an ¾” open end wrench, fully tighten down the eight (8) ½”-13 nuts securing the bumper (23172) to the brackets (22226 & 22227).

2 6 . Reconnect the factory wiring harness main connector and both fog lights.

2 7 . Note: if your truck is not equipped with sensors, use the provided 1-1/4” plastic sensor plugs to fill the sensor holes (50250-HW).

M A I N T E N A N C E / C A R E 1. Inspect all parts on the winch, winch mount, and related hardware prior to each use. Replace all hardware that appears rusted or deformed. 2. Inspect all nuts and bolts on the winch, winch mount,, and related hardware prior to each use. Tighten all nuts that appear to be

loose. Stripped, fractured, or bent bolts or nuts need to be replaced. 3. Check all cables prior to use. Replace cables that look worn or frayed. 4. Check all moving or rotating parts. Remove debris that may inhibit the part from moving freely.

CARELESS INSTALLATION AND OPERATION CAN RESULT IN SERIOUS INJURY OR EQUIPMENT DAMAGE. READ AND UNDERSTAND ALL SAFETY PRECAUTIONS AND OPERATING INSTRUCTIONS BEFORE INSTALLING AND OPERATING THIS PRODUCT.

110912-4