112613.A0 - EVO Winch Operators Manual

KNOW YOUR REMOTE

FIRST TIME OPERATING INSTRUCTIONS System Check Perform system check: 1. Check fasteners and make sure they are tight and to proper torque.

CLUTCH OPERATION: WARNING Never engage or disengage clutch if winch is under load, winch rope is in tension or drum is moving. NOTICE Always ensure the clutch is fully engaged or disengaged when operating winch. When the clutch is engaged, the gear train is coupled to the winch drum and power can be transferred from the winch motor. When the clutch is disengaged the drum is in the freespool position and the gear train and winch rope drum are uncoupled allowing the drum to rotate freely. The clutch lever ( specific to certain models ), is typically located on the winch housing opposite the motor and controls the clutch position. To prevent damage, always fully engage or fully disengage the clutch lever. SPOOLING OUT WARNING Never operate winch with less than 5 wraps of wire rope or/10 wraps of synthetic rope around the drum. Rope could come loose from the drum. WARNING Always keep hands clear of winch rope, hook loop, hook and fairlead opening during installation, operation, and when spooling in or out. WARNING Always wear heavy leather gloves when handling winch rope. Freespooling is generally the quickest and easiest way to spool out winch rope. Before freespooling winch rope out from the winch, power-out enough rope to remove any tension the winch rope might be under. Disengage the clutch. Then freespool by manually spooling out enough winch rope for the winching operation. See The Basic Guide to Winching Techniques for more information, found online at: www.warn. com. NOTICE Do NOT power out more than 30ft without allowing the winch to cool for 20 minutes before powering rope back in. Instead, place the clutch in freespool and pull the rope out by hand. WARNING Always use supplied hook strap whenever spooling winch rope in or out.

Wireless Deactivation

4.

3 SEC

=

2. Verify all electrical wiring to all components is correct and be certain that all connections are tight. 3. Verify there is no exposed/bare wiring, terminals or cable insulation damage. 4. Read The Basic Guide to Winching Techniques completely before operating your winch (www.warn.com). Once you have performed a system check, you are ready to perform “First Time Operating Instructions”. First Time Operating Instructions In this section, we’ll show you the first time operating instructions for effective basic winching. For complete winch operation and techniques read the Basic Guide to Winching Techniques found online at www.warn.com WARNING Never use winch as a hoist or to suspend a load. WARNING Never use winch to lift or move persons. REMOTE CONTROL: WARNING Always keep wired remote control lead and power cord clear of the drum, rope, and rigging. Inspect for cracks, pinches, frayed wires or loose connections. Damaged components must be replaced before operation. WARNING Never leave remote control where it can be unintentionally activated. WARNING Never leave the winch remote control plugged in when installing, freespooling, rigging, servicing or when the winch is not being used. The remote control provides control of the power-out (forward) or power-in (reverse) rotation of the spooling drum. Do not leave the remote plugged into the winch when not in use. Leaving the remote plugged in, may result in accidental activation and/or battery drain.

Winching Function

1.

Storage

1.

WARN INDUSTRIES 11

WARN INDUSTRIES 12

Powered by