INSTALLATION INSTRUCTIONS
14. Locate the black cable (A3) and carefully route it through the hole you cut in the grommet.
BLACK
RED
15. Continue to route the cables toward the battery and along the edge of the vehicle so the cables tuck under the harness and interior trim pieces removed in the earlier steps. TIP: Attaching a piece of wire or rope to the ring terminal end of the cables will help you pull the cables along.
11. Locate the long red power cable (A1) and protective corrugated tubing (A8) included in your extension kit. 12. Install the plastic tubing around the power cable with the tubing beginning at one of the ring terminals. NOTE: Use electrical tape on the ends of the sheath to hold it in place.
A8
16. Using a piece of wire or rope attached to the ring terminal end of the cables, carefully feed the cables under the interior wheel well trim until you can see your piece of wire/rope near the battery side and then finish pulling the cables to the battery.
A1
13. Starting with the ring terminal side of the red cable that is not up against the protective tubing, route it through the hole created in the grommet in or dislodge it from its position. NOTE: Ensure that the ring terminal with the protective plastic tubing next to it will be in the engine compartment and that the plastic tubing around the red cable passes through the grommet and fire wall. The plastic tubing should only go about 6 inches into the interior cabin. rubber grommet. Be careful not to push the Route this end first
©2025 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
5
112312A0
Powered by FlippingBook