INSTALLATION INSTRUCTIONS
3. 4.
Remove the front interior scuff plate trim. Continuing in the interior driver side, use a panel pry tool and remove the kick panel trim.
8.
Remove the storage tray/cup holder panel. NOTE: This doesn’t need to be fully removed, just enough to be able to feed wire through.
5. 6.
Remove the rear scuff plate trim. Remove the lower pillar trim.
9.
Remove the clip from the air duct that is under the storage tray/cup holder for more access into that space
7.
Partially remove the rear interior wheel well trim.
WARNING Always use extreme caution when cutting on any vehicle. Make sure that all electrical wires, and other objects are not punctured or damaged when cutting on the vehicle. Thoroughly inspect the area before cutting and relocate any objects that could be damaged. Failure to inspect the area to be cut may result in vehicle damage, electrical shock, fire or personal injury. 10. From inside the engine compartment on the driver side, locate the rubber grommet on the fire wall.
Ensure all wires are safely out of the way and carefully cut a small hole in the grommet to allow the new wire to be threaded through.
©2025 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
4
112312A0
Powered by FlippingBook