23. In order to have room to drop the winch into position, you will need to move the transmission cooler out of the way. You do this by removing two bolts (one in each bracket) and push cooler back out of the way. NOTE: Save hardware as you will be reinstalling later.
Remove
Figure 17
24. Remove the O.E. bolt that holds the slip tube into vehicles frame (both sides).
CAUT I ON
Remove
• Always use assistance when moving or lifting heavy parts.
25. With assistance, align the winch mount (A1) to stock frame rail.
Figure 18
26. Loosely , attach to frame rail. NOTE: Refer to exploded view on page 3. a. Reinstall the three nuts (removed in step 17). b. Install provided hardware (B1, B3, B4, B2, B5). TIP: You may want to pull back inner fender liner for better access - be sure to reinstall when finished.
A1
27. Using slots in mount, center the mount to front of vehicle. Once centered, tighten hardware.
28. Slide the winch mount lower support brackets (A2) between the vehicles plastic and along side the winch mount.
29. Install bracket using original OE bolt and hardware supplied in this kit (B5, B2, B3 and B1).
Figure 19
9
100125A1
©2018 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
Powered by FlippingBook