30. Install factory bolt through lower support bracket and slip tube. Tighten.
Trim
31. To relieve stress on plastic, trim plastic around support bracket as necessary.
Lower support bracket
Install OE bolt
Figure 20
32. Install fairlead to winch mount, using fairlead hardware.
Winch
Transmission Cooler
NOTE: Make sure if installing synthetic rope winch you install the winch rope to winch drum before installing the winch to mount! 33. Spool a bit of winch rope out and feed winch rope through winch mount and out fairlead. TIP: You may install the winch mounting nuts into winch before lowering into its location. Use tape so nuts don’t slide out. This will make installation easier. 34. Install winch by lowering right side down through the opening where the hood latch was located and just to the left of the power steering cooler.
Figure 21
35. Once inside the pocket, lower the other side of the winch into the carrier.
36. Install winch using winch mounting hardware and instructions found in your winch kit.
Bent bottom latch
37. Route your winch wires. TIP: Use zip ties to keep your wires in a mechanically sound position.
38. Reposition transmission cooler back in place and install bolts previously removed and tighten. 39. Reinstall cross bar, hood latch ( You may need to trim or bend the bottom of hood latch to keep it from hitting the top of the winch . ) and power steering cooler bolt.
40. Plug in lower harness and re-clip to cross bar.
Figure 22
10
100125A1
©2018 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
Powered by FlippingBook