INSTALLATION INSTRUCTIONS
9. Using an 18mm socket wrench, remove the four bolts attaching the tow hook to the frame (each side). Remove the tow hooks.
12. From the inside of the stock bumper, use a panel pry tool to remove the push pin clips.
13. If equipped, remove the parking sensors from the housings. NOTE: Be sure to mark the location (LH/ RH, Inner/Outer) and orientation (Top/Bottom) of each sensor. TIP: Numbering each sensor with tape and marking with a paint pen works well. 14. Remove the sensor housing from stock bumper. NOTE: Be sure to mark the location (LH/RH, Inner/ Outer) and orientation (Top/Bottom) of each sensor carriage.
10. Using an 18mm socket wrench, remove the four nuts attaching the underrun guards to the bottom of each frame rail (each side). Retain for later reinstall.
Park Sensor Harness
Sensor
Sensor Housing
11. Using an 8mm socket wrench, remove the four screws in each fog light bracket to remove them from the bumper.
For illustration purposes only
15. Install the left and right frame mounts (A3/A4) using two 1/2”-13 bolts (B10) four flat washers (B12), two lock washers (B11) and two nuts (B13). Refer to exploded view on page 3. 16. Reinstall underrun guard bolt strips that were removed in Step 10.
Bolt Strips
A4, B10, B11, B12 & B13
A3, B10, B11, B12 & B13
©2023 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc.
5
110784A0
Powered by FlippingBook