I N S T A L L A T I O N I N S T R U C T I O N S
27. With assistance, lift the bumper up to the brackets (22226 &22227) and secure it loosely using the provided four (4) bolt strips (20296) and eight (8) 1/2”-13, yellow zinc hex nut, flat washers, lock washer. (Figure 27-28) (50250-HW)
Figure 27
Figure 28
28. With assistance of two, lift and center the bumper to the vehicle and using an ¾” open end wrench, fully tighten down the eight (8) ½”-13 nuts securing the bumper (107004-6) to the brackets. (22226 & 22227)
29. Reconnect the factory wiring harness main connector and both fog lights (if equipped)
30. Note: if your truck is not equipped with sensors, use the provided 1-1/4” plastic sensor plugs to fill the sensor holes (50250-HW). (Figure 29)
Figure 29
15
Powered by FlippingBook