I N S T A L L A T I O N I N S T R U C T I O N S
24. After the epoxy has cured, fully seat all four (4) sensors into the sensor housings being mindful not to distort the rubber sensor isolator that sits around the sensor tip. Be sure both sides of the sensor housing are fully clipped on the sensor. 25. Route and zip tie the factory wiring harness to the bumper (107004-6) with the main factory connector being on the passenger wing.
26. Install the light housings (94888-94889) into the bumper using the #10 stainless steel bolts, flat/lock washers and nuts (50250-HW). (Figure 26)
Figure 26
Optional: If you are installing a winch with this bumper installation, do so now. Use the bracket or clamps supplied with the winch to mount the control pack; be sure to install the winch ground strap before installing the winch in the bumper. Once the control pack is installed on the winch, insert the winch into the bumper. The control pack should be facing up with the four front mounting holes facing forward. Insert the winch by first tipping the end with the clutch lever up and inserting the control pack end in the bumper first. Then insert the clutch lever end in the bumper. Use the hardware supplied with the winch to properly mount the winch to the bumper. Follow the instructions supplied with the winch for the proper bolt location. The winch comes with two different length 7/16” bolts, so read the instructions with the winch to ensure the proper locations.
If not installing a winch, a license plate may be installed onto the front face of the bumper. (Hardware not included.)
14
Powered by FlippingBook