INSTALLATION CONT. NOTE: Some TJ model vehicles may not have all 8 mounting locations on the rear frame area. If all 8 locations are not in the frame, measure the supplied bumper mounting points and match these measurements on the frame. Drill the frame holes to 7/16". See Figure 1.
Figure 1
· On YJ models, use the supplied 3/8" bolts, lockwashers, and washers in all 8 mounting locations. Torque 3/8" bolts to 35-38 ft lbs. Insert the two spacers, one on each side, between the bottom bumper tab and the bottom of the frame. Install the bottom bumper bolts, using the 2 supplied 7/16" bolts, lockwashers, and washers, torque 7/16" bolts to 42-45 ft lbs. · On CJ models, use the supplied 3/8" bolts, lockwashers, and washers in all 8 mounting locations. Insert the four spacers between the frame surface and the bumper mounting surface. It is necessary to space the bumper away from the frame for proper clearance. Torque 3/8" bolts to 35-38 ft lbs. Insert the two spacers, one on each side, between the bottom bumper tab and the bottom of the frame. Install the bottom bumper bolts, using the 2 supplied 7/16" bolts, lockwashers, and washers, torque 7/16" bolts to 42-45 ft lbs.
WARN INDUSTRIES, INC. g 12900 SE CAPPS ROAD g CLACKAMAS, OR 97015-8903
(503) 722-1200 g CUSTOMER SERVICE LINE 1-888-722-6730 g FAX (503) 722-3051
© 2005 Copyright Warn Industries, Inc. All rights reserved.
WARN INDUSTRIES
PAGE 2
62060 Rev. B1
Powered by FlippingBook