IV. Installation
1. Prior to installing the plow mount, the vehicle must be prepped. Remove the plastic fascia or any aftermarket installed bumper from the front brush guard. The parts will interfere with plow operation. If vehicle is equipped with a Warn winch mount, it will be necessary to remove the lower half of the winch mount first to remove plastic fascia. See figure 1. Fascia will not be reinstalled on vehicle during plow operation.
Remove fascia
Remove lower Winch mounting bracket
Note: Fascia can be reinstalled on vehicle. See fascia trimming instructions at the end of this instruction.
Figure 1
2. Reinstall the lower winch bracket removed in step 1. Remove the lower m12 bumper fasteners. See figure 2.
Fastener location
Figure 2
3. Place plow mounts (A1,A2) into position. See figure 3. Install fasteners (B1,B2,B3) (B4,B5,B6,B7) as shown in the parts list. Do not tighten at this time.
Slide over end to position
Insert B6 here
Note: To install fastener B6, slide fastener in through opening, under bumper tube. See figure 3.
Figure 3
WARN® INDUSTRIES
PAGE 4
83511A3
Powered by FlippingBook