INSTALLATION INSTRUCTIONS
25. Place the clip nuts (B9) on the trimmed filler panel, aligning holes.
29. If installing a winch/fairlead, do so now following the winch manufacture’s instructions provided with the winch.
CAUTION Always use assistance when moving or lifting heavy parts.
26. Install the ACC filler panel to the inside of the bumper using the two black 10-24 screws (B8). NOTE: The ACC sensor can be adjusted for calibration after the bumper is installed by removing the filler panel to access the top stock stud.
30. With assistance, lift the new bumper in position and slide the strip bolts into the mounting holes on each frame bracket. 31. Loosely secure the bumper with the 1/2”-13 nuts (B13) onto the bolts to hold the bumper in place. 32. Align the bumper into the correct position (center left and right), and then fully torque down the hardware. TIP: Tighten the bolts into the truck frame first and then the nuts on the strip bolts.
27. Install the ACC sensor to the new ACC mount (A2) provided in this kit, using the factory ACC bolts.
33. Reconnect ALL wiring harnesses.
34. Complete your winch wiring installation following your winch installation instructions.
35. Confirm all hardware is has been tightened to recommended torque.
28. Install ACC sensor mount to bumper using the 1/4”-20 bolts (B5), flat washers (B7) and nuts (B6). NOTE: the OE bolts may interfere with the winch. If this is the case, slight trimming of the bolt length may be necessary to provided clearance.
Installation is now complete
B5, B6, B7
©2023 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc.
7
110784A0
Powered by FlippingBook