I N S T A L L A T I O N I N S T R U C T I O N S
** Note: Driver side shown and passenger side disassembly process is similar**
4. Using an 8mm Socket wrench and plastic panel pry tool, remove the two (2) screws and one (1) push pin from the rear splash shield trim. (Fig. 3)
(Figure 3)
5. Using an 10mm socket wrench and plastic panel pry tool, remove the twelve (12) screws and two (2) push pins from the inner fender and set aside for trimming. (Fig. 4 - 5)
(Figure 4)
5
Powered by FlippingBook