I N S T A L L A T I O N I N S T R U C T I O N S
19. Using the provided epoxy, secure all six (6) OEM sensor housings in their appropriate sensor cutout in the bumper. (Fig. 18)
**Note: If you do not have sensors you will insert the grommets supplied in the hardware kit**
(Figure 18)
20. After the epoxy has cured, fully seat all six (6) sensors into the sensor housings being mindful not to distort the rubber sensor isolator that sits around the sensor tip. Be sure both sides of the sensor housing are fully clipped on the sensor.
21. Route and zip tie the factory wiring harness to the bumper with the main factory connector being on the passenger wing.
22. Install the provided light inserts (94888 and 94889) using the #10 hardware along with a 10mm wrench and 3mm Allen wrench. (Fig. 19).
(Figure 19)
12
Powered by FlippingBook