I N S T A L L A T I O N I N S T R U C T I O N S
16. If equipped, remove the engine heater plug located on the driver side of the truck bumper. Push the bumper in against the spring and turn counterclockwise, once unclipped pull out from the bumper. (Figure 17)
Figure 17
17. Carefully remove the four sensors and sensor housings from the bumper by spreading the housing clips out and pushing the sensor out simultaneously. Make sure to mark the position of each housing for installing into the WARN bumper. (Figure 18)
Figure 18
10
Powered by FlippingBook