TROUBLESHOOTING
FINAL ANALYSIS AND MAINTENANCE
Trouble Shooting/Error Conditions
Before örst operation
After each use
Check
Every 90 days
Problem Error Message Possible cause
Corrective action
Take time to fully read the Instructions and/ or Operations Guide, and/or Basic Guide to Winching Techniques, in order to understand your winch and its operations Check fasteners and make sure they are tight and to proper torque. Replace damaged fasteners. Verify wiring to all components is correct and be certain that all connections are tight. Verify there is no exposed/bare wiring, terminals or cable insulation damage (chaöng/cutting). Cover any exposures with terminal boots. Repair or replace damaged electrical cable. Inspect rope for damage. Replace rope immediately if damaged. Keep winch, rope and switch control free from contaminants. Use a clean rag or towel to remove any dirt and debris.
X
Make sure your Advanced Wireless Remote Control is within range.
Low wireless strength
X
X
Wireless Remote Control Activation Switch is in the OFF position Winch control pack is under water. Wireless signal will not transmit under water. Tension or Load exists on the winch, preventing the clutch from disengaging.
Winch is not operating
Turn ON the Wireless Remote Control Activation Switch
X
X
Winch control pack needs to be above water to receive wireless signal. See www. warn.com for accessories.
X
X
X
X
X
Power-out winch until winch rope is no longer under load.
X
Check the 4-pin remote controlled clutch connector on the back of the control pack to be sure it is örmly connected.
Remote controlled clutch does not disengage when requested
The remote controlled clutch is disconnected from the control pack.
Charge Remote
X
X
The remote controlled clutch is damaged.
Contact WARN® customer service for further information.
Disposal Batteries should not be disposed of in general household waste. Observe the local waste disposal regulations, details of which can be obtained from your local authority.
Take time to fully understand your winch and the winching operation by reviewing the Basic Guide to Winching Techniques found online at: www.warn.com.
Charge the remote battery See charging instructions on page 13.
Remote will not operate
The remote battery is critically low.
All electrical and electronic equipment must be disposed of separately from general household waste using the sites designated by local authorities. If a product displays this symbol of a crossed-out wheelie bin, the product is subject to European Directive 2012/19/EC.
For further information or any questions contact: WARN INDUSTRIES, INC. 12900 S.E. Capps Road, Clackamas OR USA 97015-8903, 1-503-722-1200, Customer Service: 1-800-543-9276 Dealer Locator Service: 1-800-910-1122 or visit www.warn.com.
Auxiliary will not turn on
Auxiliary is not connected
Check auxiliary connector and cables.
Accessories wiring faulty; Accessory electrical load is to high. * Auxiliary systems must be rated for 12v and draw less than 16 amps.
The appropriate disposal and separate collection of used equipment serve to prevent potential harm to the environment and health. They are a prerequisite for the re-use and recycling of used electrical and electronic equipment. For further information on disposing of your used equipment, please contact your local authority or your refuse collection service.
Auxiliary short circuit
Check wiring; reduce electrical load.
Wireless signal strength is low
Decrease distance between remote control and winch.
WARN INDUSTRIES 23
WARN INDUSTRIES 24
Powered by FlippingBook