WIRING DETAILS:
• Route black lead Wire from J3 terminal on Circuit Board through Wire guides up into handle
to Trigger Switch.
• Route white lead Wire from J4 terminal on circuit board through Wire guides up to Trigger
Switch.
Route the Motor wires as shown.
•
• Route Brush leads from Brushes up to Trigger Switch.
• Use tie strap to secure Motor Wires and Brush Wires to the right hand frame.
• Attach green Wire from Power Cord assy. to frame as shown.
• Route Brown lead from power cord assy to the bottom terminal of rocker switch.
• Install the terminal from green wire from the power cord assy and Terminal from green lead to
the right frame and secure underneath cap screw.
• Route blue lead from power cord assy to the N4 filter terminal.
• Route black J2 lead from circuit board to the U1 filter terminal.
• Route J4 lead from circuit board to the U3 filter terminal.
• Secure power filter assy to motor housing and rear Tie rod using Tie strap.
• Install Black lead from top terminal of rocker switch to the L2 filter terminal
• Route green lead from ground terminal of filter to right frame ground location.
• Attach green wire from power cord assy. And power filter ground terminal to frame.
• Refer Wiring diagram 77483 for installation wiring schematic .
Switch Pin-out Table Manufacturer name is embossed on switch.
987605A1
Page 38 of 49
Powered by FlippingBook