3. PULLZALL TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
1.1 PullzAll does not power in or pulls slowly.
Loose connection on Motor terminals.
Be sure all connections are tight and clean. Do not let bottom nut or stud turn while tightening.
Check the speed mode selected.
Change mode as required.
Burnt main contact point, or poor contacting action.
Worn Brushes.
Replace Motor Assembly
Weakened brush springs.
Poor Wiring connections.
Rope is interfacing with Tie Rod or other part of PullzAll.
Rewind Rope on Drum, so that it is level and not rubbing on other parts of PullzAll.
Motor is hot.
Allow PullzAll Motor to cool for at least 10 minutes between short pulls. Increase cooling time for heavy loads or long pulls.
Abnormally worn Bushing.
Replace PullzAll.
1.2 Noise
Worn or Broken Gearset.
Replace PullzAll
Motor malfunctioning.
Replace Motor.
1.3 Motor is running but not pulling.
Damaged Geartrain
Replace PullzAll
986765A1.doc
Page 48 of 50
Powered by FlippingBook